Joshua

High-speed nail making machine is a special-shaped nail that can be applied to nail shooting, linoleum killing, high-speed welding nail machine and other styles. Its design uses advanced technology to make it more convenient and safe to operate, and its appearance is more beautiful. The structural design is relatively compact, using a plunger-type Nail machine supplier structure, such a mechanism can better ensure that the products produced are better, the noise generated during operation is also lower, and the impact force is relatively small.
(1) Surface pretreatment: for wires with dirty surfaces and more impurities, they should be cleaned and dried before pulling; For wires with more oxide scale on the surface, they should be finely acidized and dried before being pulled; For wires with skin, pits, heavy skins and other phenomena on the surface, they should also be repaired and then pulled by the polishing machine;
(2) Heat treatment: For wires with excessive hardness or uneven hardness, the hardness should be reduced by annealing or tempering first, and the wire should be maintained to be good and uniform before pulling.
In the process of using pneumatic screw gun or inspection, it is found that there are problems with pneumatic tools, which often cause unnecessary trouble to our use, how to check and repair as soon as possible Nail machine manufacturer is particularly important.
1, (automatic return) is due to a foreign body out of the switch or due to the air vent is not open or the switch spring is biased. Either the needle is off, or the tip is shallow.
2, (half needle) there is no oil or less oil in the cylinder.
3. (Cut the switch seal gas leakage) Check whether the cushion has foreign bodies, whether the gun needle sealing ring is damaged, or change the gun needle.
4, (switch leakage) open the switch to check whether the thread has slippage, and then look at whether the stem of the switch has aluminum or foreign matter.
5. (Small stroke) Grind the trigger with a grinding wheel.
6. (Pipe fitting leaks) Reapply the 704 adhesive.
7, (buckle the switch leak) A, change the switch valve seat B, the vent leak to change the shell.
8, (cylinder head leakage) open the cylinder head knock out the iron nail machine cylinder, check whether the cylinder sealing ring is broken, if not, and then look at whether the shell wall is uneven or there are sand holes or foreign objects.
9. (Snap the cylinder head leaks) Open the cylinder head and check that all the sealing rings inside have no foreign bodies.
10, (long return) The problem is that the sealing pad hole is small or biased.